Jining Huichuang Trade Co

Non-carbon epoxy electrostatic conductive anti-corrosion topcoat,
Shangqiu City electrostatic conductive anti-corrosion topcoat price
Product introduction:
Composition features:
The coating is divided into base Paint and curing agent, primer points, curing agent B component.
Construction instructions:
Surface treatment: The conductive anti-corrosion coating requires surface sandblasting, and the rust removal level should reach the level specified by B/3. Treated surfaces should be primed within hours.
. Construction environment During construction, it is strictly forbidden to mix water, sand, cotton yarn and other foreign matter into the coating. If it encounters windy sand, rain, snow and heavy fog, construction must be stopped to ensure the quality of the coating.
Before preparing and using the paint, the two components /B should be fully stirred evenly, and then stirred evenly before construction. When conditions permit, it is recommended to make a small sample first for proportioning testing.
, Construction method of electrostatic corrosion-conducting coating can use ordinary spraying, high-pressure airless spraying, brushing and other processes. The trial period of coating construction is generally no longer than four hours. When the temperature is high, the trial period of construction will be shortened accordingly, and the paint should be used as it is. The next coat can be applied when the previous coat of paint reaches surface dryness. After construction is completed, the spray gun, feeding pipe, paint brush, etc. should be cleaned in time with solvent to prevent residual paint from solidifying and affecting next use.
When the viscosity of the thinner paint is too high, it can be diluted with the special thinner produced by our company. The dosage should not exceed the amount of paint.
. Coating structure: It is recommended to use one base and three-sided coating structure for electrostatically conductive and anti-corrosion coatings. The coating dosage is ./square meter and the total dry film thickness of the coating is -. A topcoat can be added to specially weighted areas.
Curing time:
Curing for -days below ℃, -days for curing at ℃, and 3-days for curing above 3℃.
Construction protection:
Workers should wear work clothes during construction to avoid skin contact with paint. Once the skin is stained with paint, it can be washed with soapy water. In severe cases, cotton gauze dipped in alcohol or gasoline can be used to wipe the skin. Do not wash your hands with thinner.
Packaging: Component/barrel Component B/barrel
Storage: The storage temperature should not be higher than ℃. It should be stored away from fire sources and avoid rain and long-term exposure to strong sunlight. During the storage period, if there is sediment in the barrel, it will not affect the use after stirring evenly.
Our company sincerely welcomes users and colleagues from all walks of life to visit the factory for inspection, negotiation and consultation! Telephone:
Factory address: West of Xiangnanmi Road at the intersection of Deyuan Road and Kaiyuan Road, High-tech Zone, Jining City. Warm reminder: Please contact us in advance before coming to the factory, our company will arrange reception in advance
!